Self Studies

Electrochemistr...

TIME LEFT -
  • Question 1
    1 / -0

    Corrosion of iron may be prevented by

  • Question 2
    1 / -0

    Fuel cells are ________ that are designed to convert the energy of combustion of fuels like hydrogen, methane, methanol, etc. directly into_________.

  • Question 3
    1 / -0

    The resistance of 0.01 N solution of an electrolyte was found to be 210 ohm at 298 K, using a conductivity cell of cell constant 0.66 cm−1. The equivalent conductance of the solution is

  • Question 4
    1 / -0

    In the primary batteries

  • Question 5
    1 / -0

    Same amount of electric current is passed through solutions AgNO3 and HCl. If 1.08 g of silver is obtained in the first case, the volume of hydrogen liberated at STP in the second case is

  • Question 6
    1 / -0

    According to Faraday’s Second Law of Electrolysis, the amounts of different substances liberated by the same quantity of electricity passing through different  electrolytic solution connected in series are proportional to

  • Question 7
    1 / -0

    When a rod of metallic lead was introduced into 0.01 M solution of Co (en)22+, it was found that 68% of the cobalt complex was reduced to Co (en)32+ by the lead. was -0.126 V.

    of the reaction was

  • Question 8
    1 / -0

    Why is KCl used in a salt bridge?

  • Question 9
    1 / -0

    In an electrolysis of an aqueous solution of NaOH, 2.8 L of oxygen gas at STP was liberated at the anode. The volume of hydrogen gas at STP liberated at the cathode would be

  • Question 10
    1 / -0

    Which of the following statements is correct about an electrolytic cell?

  • Question 11
    1 / -0

    On passing electric current, the quantity of deposition of a metal on cathode depends on the

  • Question 12
    1 / -0

    Calculate the mass of copper that will be deposited at the cathode in the electrolysis of a 0.2 M solution of copper sulphate when quantity of electricity equal to that required to liberate 2.24 L of hydrogen at NTP from a 0.1 M aqueous sulphuric acid is passed. (Atomic mass of Cu = 63.5 u) 

  • Question 13
    1 / -0

    Consider the cell:

    Cd (s) | Cd2+ (1.0 M) || Cu2+ (1.0 M) | Cu (s)

    If we want to make a cell with a more positive voltage using the same substances, we should

  • Question 14
    1 / -0

    If four moles of electrons are transferred from anode to cathode in an experiment on electrolysis of water, the total volume of the two gases produced at STP will be

  • Question 15
    1 / -0

    In an electrolytic cell, which of the following statements is not true?

  • Question 16
    1 / -0

    Salts of A (atomic weight 7), B (atomic weight 27) and C (atomic weight 24) were electrolysed under identical conditions using the same quantity of electricity. It was found that when 2.1 g of A was deposited, the weights of B and C deposited were 2.7 g and 3.6 g, respectively. The respective valencies of A, B and C are

  • Question 17
    1 / -0

    Which of the following compounds is prepared on a large scale by the electrolysis of NaCl? 

  • Question 18
    1 / -0

    Which of the following solutions is used as an anti-rusting solution? 

  • Question 19
    1 / -0

    A secondary cell after use  can be ________ by passing current through it in the ________ so that it can be used again.

  • Question 20
    1 / -0

    Which of the following statements regarding dilution of an electrolytic solution is correct?

  • Question 21
    1 / -0

    In corrosion, a metal is ______ of electrons which --------- to form oxides and hydroxides.

  • Question 22
    1 / -0

    A solution containing one mole per litre of each Cu(NO3)2, AgNO3, Hg2(NO3)2 and Mg(NO3)2, is electrolysed by using inert electrodes. The values of standard electrode potentials in volts are Ag/Ag+ = +0.80, 2Hg/Hg22+ = +0.79, Cu/Cu2+ = +0.34, Mg/Mg2+ = -2.37. With increasing voltage, the correct sequence of deposition of metals on the cathode will be

  • Question 23
    1 / -0

    When electric current is passed through a cell having an electrolyte, the cations move towards the cathode and the anions towards the anode. If cathode is pulled out of the solution, then

  • Question 24
    1 / -0

    How many hours does it take to reduce 3 mol of Fe3+ to Fe2+ with 2.0 A current? [F = 96500 C]

  • Question 25
    1 / -0

    Which of the following metals forms a protective layer of oxide to prevent corrosion?

Submit Test
Self Studies
User
Question Analysis
  • Answered - 0

  • Unanswered - 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Submit Test
Self Studies Get latest Exam Updates
& Study Material Alerts!
No, Thanks
Self Studies
Click on Allow to receive notifications
Allow Notification
Self Studies
Self Studies Self Studies
To enable notifications follow this 2 steps:
  • First Click on Secure Icon Self Studies
  • Second click on the toggle icon
Allow Notification
Get latest Exam Updates & FREE Study Material Alerts!
Self Studies ×
Open Now