Physics Test - 65

Max well is the unit of magnetic flux.

It is useful to have a property of a material that is independent of the size of the sample and can be use to compare its elastic properties with another - this is called the Modulus of Elasticity for the material.

The modulus of elasticity is defined as:

Modulus of elasticity = Stress / Strain

There are three types of moduli. They are :

(a) the Young Modulus - tensile and compression longitudinal stress

(b) the shear modulus - a shearing stress

(c) the bulk modulus - volume changes of the specimen.

The green house effect. The waves of smaller wavelength from the sun enter inside the car through the glass windows and are absorbed. The waves of larger wavelength emitted from inside cannot get out through the glass, but remain inside and make it terribly hot.

When the piece of iron is lowered into the water, the water level in the bucket increases. And so the pressure at the bottom of bucket also increases. Thus the total thrust at bottom also increases. Therefore the spring balance reading increases.

The weight of the man mg is acting on the floor. As the lift is moving up with an acceleration, say a, the man too in it is having this acceleration. The force producing this acceleration is ma. By Newton's third law, this force will have an equal reaction pressing the floor equal to ma. Therefore the total resultant reaction on the floor is mg+ma = m(g+a) which is mg, the weight of the man.

Earlist thermometerr was developed by Galileo.

To produce controlled energy i.e energy at a controlled or steady rate, the number of fissions per second must be controlled and maintained at that rate. Excess neutrons should be absorbed by control roads like cadmium.

Both the floor and the carpet have the same temperature as both are exposed to the same atmosphere. But the former conducts away the heat from the feet better than the carpet as the latter is a non-conductor. So the feet losing more heat, the floor appears cooler to the feet.

The water rise in a capillary tube dipped in water is such that the weight of water in the tube above the surface of water in the vessel is equal to (balances) the upward force due to surface tension. So it is clear that if the the bore (radius) to the tube is decreased, the height of the water column in it must be greater.

When the switch is ON, in a tube light choke is nothing but the coil/ballast ( inductor) which is used to induce the high voltage across it. as we know that inductor has property to induce high voltage for the brief period of time, this high voltage is required to ionize the gases in the starter.